Knob Sand

Knob Sand

reconstruction and painting of fixed gear bikes?

Can I use Bondo to fill a small hole in my top tube? Oh, and I primer before painting the picture? I already sanded. but my friend says that the thin layer of paint on the frame will act as a primer. One last thing, how I remove the brake control on the top tube? i dont think so. chassis 70 Schwinn Sprint Oh, and if I do not have a torch, is it a tool you can buy that can remove modules solder?

Yes, Bondo works well to fill the hollow .... I made myself several times. Be sure to Scratch the first metal. In regard to painting, depending on the paint there and the painting that you will now use .... and the amount of paint you left behind, then you might be able to simply put the new paint on top of that, without primer. If you want the best paint job, However, a brush or strip all the paint off, use a primer of consistent quality is to go with the paint you want and follow all the usual steps you would if you were painting all metal or bodywork. You can do store pretty cheap car or you can find great use of a body shop, if you make the frame being prepared and ready to go. just to answer another question about welding cable-ons .... because now I know that you are editing a job, I would say that the heat of the discharge if you feel comfortable with a torch and steel. Good luck, have fun with the project, will be proud of him! : O)

Shot in the Dark revelation of Bonita Springs, where golfers: Highland Woods, No. 15, 101 yards, driver