Vintage Electronics Blogsphere

This problem Hestar table fan was not working, even if you have gone "On". They heard a noise in the engine and when I try to turn the screw me seemed to be fixed! In law, a good fan when to turn the propeller must rotate according to the force exerted on it. It might be time along the accumulation of dust that had jammed the motor shaft to prevent running smoothly.

Once the back cover and handle have been removed, I saw a lot of dust and dirt around the engine. I used a vacuum cleaner with a brush to clean dust. You can also see a start motor capacitor connected to another engine. This type of capacitor metallized polypropylene film. The function of capacitor start motor (AC motor capacitor) is to provide the push that "electric" to rotate the engine started. Without a capacitor start motor (as when an open circuit or burns) when voltage is applied, the motor will sit there and hum. But if you were to enter the shaft (or propeller) and a spin, the engine must (usually) and operate normally. I do not think that the capacitor has a problem because the symptoms is the tree stuck turn it.

Anyway I took the capacitor and check with a capacity meter to see if digital capacity is in the range or not. The value was, and is slightly lower than the tolerance (the tolerance for this type of capacitor is about 10%). If the value of the capacity is very low then I will replace a new one. Please be sure to get a replacement with the same or higher voltage and possibly with the same capacity. You can easily get a starter motor capacitor any electronic distribution. I congratulate start capacitor and maintenance of the fan.

First I poured the oil on the basis of causing contact Philip shaft difficult to turn. The shaft rotates once (shot by my hands) without problems now, was oil. When I turn on the fan "On" again, starting the engine to run! I fan and apply new grease to form the back, which controls the fan if you want to be "always" or "Spin" (do not use the oil spray, which can use the fast train).

After it was over, I tested the fan functioned as a new fan! The table service is not hard fan and you can try a service in your home. Remember, safety must come first, be sure to unplug the Power Cord before to begin to dismantle the fan in the other.

About the Author:

Check out the two links below. You will be pleasantly surprised to find out that LCD and Electronic Repairs are so Easy and Highly Profitable for even a novice. You can learn the repairing secrets easily.

Find out How to Repair Any LCD Monitor - It is a breeze!

Learn the Secrets of Testing Electronic Components.

Article Source: ArticlesBase.com - How To Service A Table Fan

[phpzonsidebar title="Amazon Products" keywords="Capacitors Lot" num="4" country="US" searchindex="Electronics" trackingid="traffi02-20" minprice="10000"]